Tampilkan postingan dengan label Oscilator Circuits. Tampilkan semua postingan
Tampilkan postingan dengan label Oscilator Circuits. Tampilkan semua postingan

Sabtu, 19 Juni 2010

Two Transistors Sine Wave Oscillator



This oscillator uses two transistors and operates the crystal in the fundamental mode. C1 and C2 should be about 2 700 pF for 1 MHz, 680 pF for 5 MHz, and 330 pF for 10 MHz. 150 pF can be used for up to 20 MHz. The output is a near
perfect sine wave. Try varying C1 and C2 for best waveform. About 2 to 6 Vpp is available.

Pulse Generator (with Transistor)



Seven-V narrow pulse from 2 Hz to 50 kHz are produced by this circuit. C1 through C4 provide frequency ranges in decode steps. R1 and R2 control the charging time of C1 through C4. R2 is a potentiometer used to set the frequency. R8
controls pulse width. Pulse width varies from 7 us to 10 ms. Depending on the frequency, R8 can be deleted if it is not needed.

Square Wave Generator

Highly-stable 60-Hz sine wave Generator



A highly-stable 60-Hz sine wave can be delivered with this circuit, which offers a different and much simpler approach to gaining a stable amplitude. Capacitor coupling the last stage removes any dc component caused by unequal zener
voltages in the clipping circuit that follows the comparator. (Reprinted with permission from Electronics Design, 11/92, p. 62.)

Audio Oscillator



A Wien bridge oscillator produces sine waves with very low distortion level. The Wien bridge oscillator produces zero phase shift at only one frequency (f = 1/2 P RC) which will be the oscillation frequency. Stable oscillation can occur
only if the loop gain remains at unity at the oscillation frequency. The circuit achieves this control by using the positive temperature coefficient of a small lamp to regulate gain (RF/RLAMP) as the oscillator attempts to vary its output.
The oscillator shown here has four frequency bands covering about 15 Hz to 150 kHz. The frequency is continuously variable within each frequency range with ganged 20 k ohm potentiometers. The oscillator draws only about 4.0 mA
from the 9-V batteries. Its output is from 4 to 5 V with a 10 k ohm load and the RF (feedback resistor) is set at about 5% below the point of clipping. As shown, the center arm of the 5 k ohm output potentiometer is the output terminal. To
couple the oscillator to a dc type circuit, a capacitor should be inserted in series with the output lead. (Texas Instruments, Linear and Interface Circuits Applications, Vol 1, 1985, p. 3-15 and 3-16.)

1 Hz Sine wave generator




This circuit produces a 1-Hz sine wave using two op amps. A single-chip dual op amp could be used as well.